ľ¹ÏÊÓƵ

1. The storage tank can be added on one side, and the instrument air can enter the tank first, and then enter the pneumatic actuator of the large control valve and gas actuator by using this method.

The function of adding a fuel tank is not to increase the pressure, but to ensure a constant pressure source. This method is based on the fact that the intake pipe is relatively small, and the air supply will not fail to keep up, causing pressure. This method is usually used for important valve natural gas reserves in emergency situations.

2. Is the response of your pneumatic actuator too slow?

If you request a faster switching speed: you can take air into a thicker tube so that when the air intake increases, the switching will speed up; like adding a fuel tank,

If your valve is larger, you can consider it if necessary, otherwise it is not necessary!!

3. One is that the signal line is bold, and the second is to add an accelerator to increase the speed.

4. When the valve switching time of the valve pneumatic actuator should be considered, pay attention to the opening and closing torque and pressure of the valve opening and closing torque,

On the premise of considering the safety factor torque, consider the speed of the intake and exhaust pipes and pneumatic accessories, pneumatic actuators, consider increasing the diameter and the choice of pneumatic valves and exhaust valves!