Wafer Type Butterfly Valve With Soft Seat
Valve Design: BS EN593/BS5155/API609/DIN3354
Face to Face: ISO 5752-20/BS EN558-20/API609
Flange Drilling: ASME B16.1 Class125/ASME B16.5 CL150/ASME B16.47 CL150/ DIN 2501 PN10-16/EN1092 PN10-16/JIS10K
Hydraulic Test: EN12266-1/API 598/ISO5208/JIS B2003
Shell Test Pressure: 24 bar/15 bar
Sealing Test Pressure: 17.6 bar/11 bar
Product Introduction
Wafer Soft Seal Butterfly Valve uses the flexibility of rubber seat, could easily achieve zero leakge, therefore is a widely applied valve in oilfield, agriculture, water & waste water and mining industries. Due to its rubber lined body materials, it is usually used in low pressure lines.
Wafer type is the common style of butterfly valve and is less expensive than the lug type. The wafer butterfly valve is installed between two flanges. The valve is kept in place by using bolts or studs and nuts from flange to flange. This type of installation, of course, makes it impossible to disconnect just one side of the piping system from the valve.
Applicable Standards
Design & Manufacture: API 609, EN 593, AWWA C504
Face to Face Dimension: API 609, EN 558
End Connection: ASME B16.5, EN 1092
Test and Inspection: API 598, EN 12266
Sizes: 2" - 48" or DN50 - DN1200
Pressure Rating: Class150 or PN10 - PN16
Materials of Valve Body: GG25, A126 B, GGG40, A536, WCB, LCB, CF8, CF3, CF8M, CF3M, etc.
Operated by: Lever, Gear, Pneumatic, hydraulic and Electric actuator.
You Might Also Like
Send Inquiry
